# Hint for using a direct connected 'Raspberry Pi Camera'

**URL:** https://community.angelcam.com/t/hint-for-using-a-direct-connected-raspberry-pi-camera/236
**Category:** AngelBox
**Created:** [September 9, 2019, 8:13pm UTC](https://community.angelcam.com/t/hint-for-using-a-direct-connected-raspberry-pi-camera/236 "2019-09-09T20:13:31Z")
**Posts on this page:** 2
**Page:** 1

<div class="post-metadata">

### Author: ![mike\_grosse](https://avatars.discourse-cdn.com/v4/letter/m/bc79bd/32.png) [@mike\_grosse](https://community.angelcam.com/u/mike_grosse)
#### Post date: [September 9, 2019, 8:13pm UTC](https://community.angelcam.com/t/hint-for-using-a-direct-connected-raspberry-pi-camera/236/1 "2019-09-09T20:13:31Z")

</div>

Hello,  
I downloaded the image and started my raspberry 3b with the ‘Camera Module V2’  
[https://www.raspberrypi.org/products/camera-module-v2/](https://www.raspberrypi.org/products/camera-module-v2/)

Then I enabled via  
sudo raspi-config | 5 Interface Options | P1 Camera  
the camera modul

Via [https://my.angelcam.com/connect/pairing-stream-selection/](https://my.angelcam.com/connect/pairing-stream-selection/)  
I can connect ( Connect DIY AngelBox|MAC adress) and view different ‘cameras’  
“We have detected 5 camera(s) …”  
but alle the devices have different IP Adresses (router etc)  
The raspberry itself is not listed.

I think there is no ‘streaming software’ installed on the raspberry. So, there is nothing to find.  
Which software would you please recommend to install for streaming?  
For a camera modul directly connected to the rasberry

thanks a lot

greetings from germany

Mike

---

<div class="post-metadata">

### Author: ![Paul](https://sea2.discourse-cdn.com/flex016/user_avatar/community.angelcam.com/paul/32/16_2.png) [@Paul](https://community.angelcam.com/u/Paul)
#### Post date: [September 12, 2019, 3:28pm UTC](https://community.angelcam.com/t/hint-for-using-a-direct-connected-raspberry-pi-camera/236/2 "2019-09-12T15:28:38Z")

</div>

Hi Mike,

unfortunately, we don’t have an image ready for RPi’s with camera modules. We’re only working with RTSP streams, you you’ll need to find a RTSP server which will be able to work with the cam module. We have tested some solution but found out that it wasn’t really stable.

Paul